Page 1 of 1
Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:01 pm
by KyleR
These are the mounting posts the brass pc is a threaded insert and takes a m2 x .4 screw to attach it to the base. It fits inside the aluminum pc.
Re: Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:04 pm
by KyleR
To make these i bent 7pcs of thin wire to shape and drilled 14 hole and just glued them in
Re: Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:06 pm
by KyleR
The tall post has a 1/4"ball bearing glued in with E6000
This part is held in with E6000 and I lightly mushroom the bottom edge
Re: Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:13 pm
by KyleR
I drilled the 7 holes with a #60 drill, the shape around it is an 1/8" letter 'U' metal stamp the other is a #1 stamp
Re: Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:16 pm
by KyleR
The sets of 3 are just glued together with E6000 and glued to the back wall.
The hex part is screwed together with the bottom one.
The Allen wrench is a 2mm.
Re: Aluminum top rack assembly
Posted: Mon Aug 25, 2025 11:26 pm
by KyleR
This is drilled thru both parts for the all thread and 2 nuts. I had to redrill the hole in the rack to 5/64".