Scavenger Workshop

Read Me First ----- This Frame is Not Build Council approved. We have built the frame to club specifics and have tested with some club parts we cannot guarantee all club parts will fit! you may need to make minor modifications for some parts after all you are a Droid builder not a Droid assembler! Parts From Xometry are made by various subcontractors and some holes may need to be reamed with a drill this is expected I have had some parts shipped smooth as butter and some needing to be filed or drilled please keep this in mind when ordering.

Tested Club Parts List
Daren Murrer R2 Dome and Lazy Susan
Doc Snider R5 Dome
Scavenger Pocket and Side Vents
Philip Wise Skins


Assembly Guide
Scavenger Frame Assembly Guide

Build OF Materials
Scavenger Frame 1.0 Bill of Materials



These files have been tested with Send Cut Send and Xometry if you receive anything different then what is shown or have received a part that is defective please contact the manufacturer. Scavenger workshop cannot guarantee manufacture defects.


Files can be found here for a small donation to charity. Subscription grants access to all files or you can choose one time purchase for $10
https://www.patreon.com/c/ScavengerWorkshop

File 1 of 3
5052 H32 Aluminum (.250")
File 2 of 3
5052 H32 Aluminum (.188")
File 3of 3
5052 H32 Aluminum (.040")



Parts List

Material List (Buy a few extra we use similar parts for other kits) Sorry about the links Spammers have ruined it for everyone

2 X 18-8 Stainless Steel Hex-Drive Flat Head Screw, M6 x 1 mm Thread Size, 25 mm Long
https://www.mcmaster.com/92125A242/

1 X Steel Hex Nut, Medium-Strength, ISO Class 8, M6 x 1 mm Thread Size
https://www.mcmaster.com/90592A016/

1 X Zinc-Plated Steel Hex Nut, Medium-Strength, ISO Class 8, M3 x 0.5 mm Thread Size
https://www.mcmaster.com/90591A250/

1 X 18-8 Stainless Steel Hex-Drive Flat Head Screw, M3 x 0.5 mm Thread Size, 15 mm Long
https://www.mcmaster.com/92125A103/

Counter sink the plates as seen below

Bottom Plate
Opposite side of Bottom Plate
Middle Plate
Top Plate
Up Rights
Small Uprights skin mounts and Utility Arm Bay




Step 1: Install Leg uprights on middle plate make sure the arrows on legs point to front of droid.

Step 2: add front uprights

Step 3: Mount bottom plate

Step 4: Mount cross plate

Step 5: Add Rear Door Up Rights

Step 6: Mount Top plate

Have we considered maybe labelling the parts with either numbers or letters?

Do we have tutorial on frame assembly?
I can't find how to install below items?

those are parts for the kick plates and door latches