WIP – Metric-adjusted Scavenger Center Leg (DXF)
Posted: Sat Jan 10, 2026 6:34 pm
Hello guys,
For the center leg, the metric version uses exactly the same geometry as Scavenger's original files.
Nothing has been modified in the design itself.
There are three files provided:
The 1.5 mm and 6 mm files are strictly identical to Scavenger's originals.
You simply need to order two pieces of each to build the full metric stack.
When converted to pure metric, the total thickness becomes 63.50 mm, compared to 63.56 mm when converting the original inch-based design.
This gives a difference of 0.06 mm, which is effectively invisible in real-world assembly.
The only downside is cost: the metric version requires two extra parts, so it will be slightly more expensive, but mechanically it is equivalent to the original inch-based design.
This is still WIP: it has not been printed or physically tested yet.
Please consider it a first pass and report any issue you may spot, thank you !
For the center leg, the metric version uses exactly the same geometry as Scavenger's original files.
Nothing has been modified in the design itself.
There are three files provided:
scav-centrev21-12mm.dxf- (194.91 KiB) Downloaded 9 times
- scav-centrev21-6mm.dxf
- (160.51 KiB) Downloaded 10 times
- scav-centrev21-1.5mm.dxf
- (160.51 KiB) Downloaded 11 times
You simply need to order two pieces of each to build the full metric stack.
When converted to pure metric, the total thickness becomes 63.50 mm, compared to 63.56 mm when converting the original inch-based design.
This gives a difference of 0.06 mm, which is effectively invisible in real-world assembly.
The only downside is cost: the metric version requires two extra parts, so it will be slightly more expensive, but mechanically it is equivalent to the original inch-based design.
This is still WIP: it has not been printed or physically tested yet.
Please consider it a first pass and report any issue you may spot, thank you !