Scavenger Workshop Drives 2.0

[Marc ph]

Scavenger Workshop Drives 2.0

Difficulty Level: Intermediate


Assembly Guide

Scavenger Drive 2.0 Assembly Guide v2408.pdf

(7.69 MiB) Downloaded 426 times

Build Of Materials

Scavenger Drive 2.0 Bill of Materials v2408 (1).pdf

(80.66 KiB) Downloaded 499 times

Files can be found here for a small donation to charity. Subscription grants access to all files or you can choose one time purchase for $10
https://www.patreon.com/c/ScavengerWorkshop

This is rev 2 only for ampflo E30 150 motors!
File 1 of 1
Process: Sheet Cutting
Material: Aluminum 5052-H32
Material Thickness: 0.125in
Finish: Standard

scavenger-Rev2_3.dxf

(249.06 KiB) Downloaded 2 times

This is the old rev 1 files with the scooter motor mount see below for wheel and sprocket replacement
File 1 of 1
Process: Sheet Cutting
Material: Aluminum 5052-H32
Material Thickness: 0.125in
Finish: Standard

scavenger_Rev1.dxf

(249.06 KiB) Downloaded 1 time

Drive Parts

[Marc ph]

If you are building Scooter Drives with REV 1

Instead of buying the Robotshop Colson wheel and the motor sprocket replace with below


Wheels are manufactured from Glass-filled Nylon. Each Traction Wheel comes assembled in 1” wide configuration and also includes all hardware for 1.5” and 2” wide configurations.


https://www.vexrobotics.com/traction-wheels.html
2 X 4" Traction Wheel • $7.99
3 X 4" Traction Tire (0.5" Wide, 2-pack) • $2.49



https://www.vexrobotics.com/25-sprockets.html
2 X 32T Aluminum Plate Sprocket (#25 Chain, 1-1/8" Bearing Bore) • $5.99



https://www.vexrobotics.com/versahubs.html
2 X 1.125” Bearing Bore Plastic VersaHub Spacer (1/2” Wide)

4 X https://a.co/d/hmJVkkK Single Split Clamp-On Shaft Collars of Metal Material 1/2 inch Bore Set Screw